HA8700 = Now That's a Hammer by Fretz Set of 3

A set of the 3 "Now That's a Hammer" from Fretz.

#1 Riveting hammer for classic planishing and narrow marks
#2 Double crosspein hammer for texture lines
#3 Double pein hammer for classic deep. round marks.

For more details...

#1 Hammer is similar to a large riveting hammer with a flat round face and a crosspein on the opposing end. The flat end will planish or hammer metal smooth; and if the metal is domed and will will leave the classic planish marks of hand wrought jewelry. The crosspein end leaves a narrow mark which is very attractive on wire jewelry.

The base of the handle features a 22mm high dome stake. The handle can be held in a vise for use.

Face #1 = 15mm diameter beveled flat
Face #2 = 14mm crosspein
Head length = 105mm
Handle end = 22mm high dome stake

#2 Hammer is a sharp crosspein texture hammer. One end is very sharp and the other end more rounded. The marks obtained on slightly domed metal look like engraved lines. The thicknesses of the lines vary depending on the end used and the force of each hammer blow.

The base of the handle features a 22mm beveled flat stake. The handle can be held in a vise for use.

Face #1 = 14mm crosspein (wide)
Face #2 = 14mm crosspein (narrow)
Head length = 105mm
Handle end = 22mm beveled flat stake

#3 Hammer is a double ended ballpein and is the classic texture hammer. The marks made are deep, round, and work very well on both flat and domed metal surfaces.

The base of the handle features a 22mm low dome stake. The handle can be held in a vise for use.

Face #1 = 12mm dome
Face #2 = 8mm dome
Head length = 105mm
Handle end = 22mm low dome stake