DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse
DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse DA3337 = Ring & Hoop Press - Large Traverse

DA3337 = Ring & Hoop Press - Large Traverse

$59.95
+ -
Add to cart
Article number: DA3337
Availability: In stock

Now make patterned or "wavy" rings and hoops without the need for a hydraulic press!  This Bangle Forming Die is easy to use. All you will need is heavy lead-filled rawhide mallet and a sturdy benchtop.

 

  • First create your bangle or hoop out of wire (we used 24ga copper washers when we played with ours).
  • Next separate the halves of the die.
  • Use the groove in the outside collar the line up the dies.
  • Place your bangle in between the halves making sure to center it.
  • Replace the top half of the die and give it a good solid WHACK!The solid steel die is designed so that the halves always line up perfectly.

 

Other patterns are available so go ahead and get creative!

The die is approximately 2" in diameter (1-1/2" inside diameter).

0 stars based on 0 reviews
Add to wishlist / Add to comparison

FDJTool.com

  • Minutes from Historic Downtown Sanford.
  • 407-629-6906
  • sales@fdjtool.com
Copyright 2019 FDJ Tool
PayPal Credit Card