DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop
DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop DA3220 = Bangle Press - Large Scallop

DA3220 = Bangle Press - Large Scallop

$52.95
+ -
Add to cart
Article number: DA3220
Availability: In stock

Now make patterned or "wavy" bangles and hoop earrings without the need for a hydraulic press!  This Bangle Forming Die is easy to use. All you will need is heavy lead-filled rawhide mallet and a sturdy benchtop.

 

  • First create your bangle or hoop out of wire (we used 14ga round copper when we played with ours).
  • Next separate the halves of the die.
  • Place your bangle in between the halves making sure to center it.
  • Replace the top half of the die and give it a good solid WHACK!The solid steel die is designed so that the halves always line up perfectly.

 

It also comes with 3 aluminum spacers to help keep your bangle centers (the spaces will get deformed during use, but that is ok).

Other patterns are available so go ahead and get creative!

The die is approximately 3" in diameter and 1-1/2" thick.

0 stars based on 0 reviews
Add to wishlist / Add to compare