The Hoke Jeweler's Torch is virtually a standard in the industry. It features fingertip control to the valves and a selection of tips from a large brush flame to a pin point flame.
Gas inlets use standard 1/4" hose. If you purchase a hose with fittings, you will have to cut off those fittings in order to use it with the Hoke torch. After cutting off the fittings on one end of the hose (preferably the end that does not fit your regulators), put hose clamps on to the hoses. You can then slide the bare ends onto the torch's gas inlets and tighten the hose clamps firmly.
Use with propane and oxygen.
Overall length is 9".